Yamaha SB168-ES Interface driver for Windows 7 - Yamaha SB168-ES Interface driver from Yamaha for

Yamaha SB168-ES Interface 1.10

Yamaha SB168-ES Interface driver from Yamaha for OS Independent

Yamaha SB168-ES Interface driver from Yamaha for OS Independent

Publisher review for Yamaha SB168-ES Interface 1.10:

Before install Yamaha SB168-ES Interface 1.10you should set a system restore point, to make sure you can rollback to your original driver in case you accidentally install another driver or select the driver for another version of the operating system.

Also, do not forget to check with our site as often as possible for new version of Yamaha SB168-ES Interface . We recommend to always use most recent version of a driver.

This package contains the necessary installation files of Yamaha SB168-ES Interface Firmware version 1.10.New features:- Now supports the Auto Configure function of the M7CL-48ES.
Installation steps:1. Connect the NETWORK jack on the rear panel of the SB168-ES unit to the Ethernet jack on the computer using an Ethernet cable.
2. Make a note of the current settings of the dip switches located on the front panel of the SB168-ES. Write down the current dip switch settings before you modify them in the next step, since you will need to return the switches to their original settings in step 8.
3. Set dip switches 5 and 6 (located on the front panel of SB168-ES) to the down position (ON), leave dip switches 7 and 8 in the up position (OFF), then turn on the power to the SB168-ES. All +48V indicators will blink and the unit will start up in Update mode.
4. Double-click [update.exe]. The SB168-ES Update Program will start up. Make sure that the fields in the "File" section indicate as follows:
- file name ：SB168-ES_PROG.bin
- product name ：SB168-ES_PROG
- version ：Version number to which the firmware will be updated NOTE:
- When running under Windows Vista / 7, the "User Account Control" dialog box may appear.
Click [Continue] or [Yes].
5. Click the [Connection] button in the “Connect and Update” column. The “product name” field will display “SB168-ES,” and the “version” field will display the version number of the SB168-ES firmware.NOTE:- If these fields are empty, your computer may not be properly connected to the SB168-ES. Please make sure that the cable is not disconnected or damaged, that the TCP/IP settings are correct, and that the SB168-ES has started in Update mode.
6. Click the [Update] button in the “Connect and Update” column. The update operation will begin. The update will take about 90 seconds. During the update operation, do not turn off the power to the unit or disconnect the cable. If update fails due to disconnection of the power cable during the update, or due to other reasons, the device may become inoperative.
7. When the “Connect and Update” section displays the message “Updating was completed. Close this Update Program” click the [X] button in the upper-right corner of the program window to close the program.
8. Turn off the power to the SB168-ES, then return the dip switches to their original settings. Return the dip switches back to the settings you noted in step 2.

Operating system:
OS Independent